A coat of beauty
to your dream.


GYPSUM PLASTER
1 COAT.

BUILDON Gypsum Plaster 1 Coat is produced from the light powder-density rock sourced from the purest mines. The advantage of our Gypsum is that it is the highest grade, pure white in colour, and 40% harder than any other Gypsum Plaster available in the Indian market. This Gypsum plaster can be applied easily and directly on all surfaces without the need for sand/cement/ plaster on the walls. The coverage in a 25Kg bag is 20 Sq. Ft. with a thickness of 12mm. The Fineness of 200 Mesh and purity over 90% ensure the best atomic bond and an absolute mirror finish.

Approved by

Applied on

Brick Wall

Block Wall

RCC Structure

Send Us Message

    Enter captcha code: captcha

    Application of Gypsum

    The surface must be clean, dry, firm & free of dust.

    Important properties like soluble salt content, thermal characteristics, shrinkage, strength, suction bonding properties etc of the background which is to plastered, should be evaluated before application.

    Gypsum plaster one coat can be applied directly on most surfaces like Brick walls/Fly ash brick/Siporex blocks/Concrete surfaces/Sand cement plaster walls etc.

    A suitable fixture can be fixed after the plaster has been set. You can put up fixtures of varying weights. Smaller ones can be supported by using steel hooks and pins, while heavier frames and objects can be accommodated with plugs and screws or suitable fixtures, adequately penetrated into the background to ensure a firm hold.

    Tools for Application

    Mixing Bucket
    Plumb BOB
    Steel Trowel
    Right Angled Scale
    Line Dori
    Aluminium Channel
    Measuring Tape
    Mixing Bucket
    Plumb BOB
    Steel Trowel
    Right Angled Scale
    Line Dori
    Aluminium Channel
    Measuring Tape

    Direction For Use

    The right way to mix is to add the powder to water, not water to the powder.
The ratio of the powder should be 1:1.30.

    Avoid mixing more powder that can be used within 12 minutes - 15 minutes.

    Do not temper or mix fresh material
once a mix has started to set.

    After taking the required amount of plaster, always fold the open end,
to protect the plaster from moisture.

    The setting time cannot be altered by diluting the mixture. For a longer setting time, the BUILDON retarder should be added.

    Features

    Single coat application

    Very smooth finish

    Can be applied directly on all walls/surfaces

    Free of shrinkage cracks

    Zero maintenance

    Compatible with all types of paints

    Pure white in colour

    Technical Specifications

    Purity

    90% and above

    Whiteness

    92%

    Fineness Mesh

    Mesh 200,

    Residue 2%

    Setting Time

    Intial 12 - 15 min.

    Final 24 - 30 min.

    Compressive Strength (Dry)

    20 N/mm2

    Coverage at 12mm thickness

    20 Sq. ft.

    Dry Bulk Density

    750 Kg / m3

    Standard Compliance

    IS 2547-1 Part 1 & Part 2

    Shelf Life

    8 months

    Application Process

    Apply a thick layer on brick wall

    Apply a thin layer on board

    Apply directly on surface

    Level it out with an aluminium channel or straight edge. Leave until partially set.

    Steel Trowel is used to scrape dead plaster off the wall

    Clean all tools

    Apply a thick layer on brick wall

    Apply a thin layer on board

    Apply directly on surface

    Level it out with an aluminium channel or straight edge. Leave until partially set.

    Steel Trowel is used to scrape dead plaster off the wall

    Clean all tools

    More Products

    Explore products that will meet your needs,